Check a Thermal Imager’s Accuracy

Tips

1. Pour crushed ice and water into the cup, and turn on the imager.
2. Mix the solution and let it stand for a few minutes.
   
3. Set the imager's emissivity to 0.95 and adjust the distance.
   
4. Point the imager at the solution to measure its temperature. To get the best effect,please measure the temperature of water surface and avoid measuring cup wall.The reading should be close to the freezing point (0 °C / 32 °F) and within the precision range.

NOTE

1.If the device fails the ice and water detection,please contact our after-sales service.

2.If the device passes the ice and water detection,it indicates that the device itself is accurate.If temperature measure If temperature measurement inaccuracies are observed, there may be issues with improper use of the thermal imaging instrument. For further details on temperature measurement inaccuracies, please refer to the article "Precision Temperature Measurement Guidelines".